Keep your non-skid decks clean and shiny. never scrub them again! - duration: 5:34. aurora marine industries 152,967 views. Clean floors with nyco floor & all surface cleaner to remove all dirt and soil. apply 1-2 even coats using a clean, high quality mop or wax applicator. allow 30 minutes to thoroughly dry between coats, longer in areas of high humidity. do not walk on floor for approximately 1 hour. let dry for several hours before replacing furniture.. Consider using a polish or buffing compound. both polish and buffing compound are abrasives, which restore the shine to your boat’s fiberglass gelcoat by removing imperfections, discolorations and scrapes in the surface, increasing the reflective shine. choose polish if your boat only needs light refinishing..
You can wax, polish, and compound by hand, but on anything but the smallest boat, your arm is going to get very tired. an electric buffer takes much of the work out of keeping a boat shining and is less expensive and less painful than elbow replacement.. Fiberglass wax. historically, boats have been maintained using either wax or polish. waxes cover the surface and provide a barrier between the elements and the gelcoat surface. waxes work well for boats in good condition, but not so well for older boats which have weathered a bit.. A while back i was working on a boat in a local yard when i happened to strike up a conversation with a fellow that owned the boat next to the one that i was working on. i immediately noticed the shine on the hull (it was a sailboat, about 35 years old) and i asked if it had recently been painted.
Comments
Post a Comment